FAST CURING POLYURETHANE TRAFFICABLE JOINT SEALANT
Description
Bostik Seal 'N' Flex FC Fast Curing Polyurethane Trafficable Joint Sealant is a fast cure high performance one component polyurethane elastomeric joint sealant. When fully cured; Bostik Seal ‘N’ Flex FC will provide a tough, flexible seal capable of cyclic expansion and compression to 50% of original joint width without primer on most substrates. Bostik Seal ‘N’ Flex FC is unaffected by ultra-violet radiation, atmospheric contamination or pollution. Its excellent weather ability enables it to retain its original properties after years of expose. (C.S.I.R.O. RILEM expose study).
Uses
- Trafficable – Plats, stairs, roads, runways, aprons, and pavements
-
Vertical – Precast, block work, aluminums, plasterboards, timber and most common building substrates
-
Pick Resistant – Prison, cells, schools, and public, amenties
-
Chemical Resistant – Service stations, hangers, aprons and bonded areas
-
Fungal Resistant – Wet areas, wash down bays, food processing
Advantages
-
Fast-curing
-
High strength
-
Chemical resistant
-
UV resistant
-
Easy to apply
-
Australia made
-
Aromatic technology
-
+25% movement
-
Abrasion & pick resistant
-
AS 4020
-
Resistant to fungals attach AS 1157.2
-
Acoustic properties
-
ISO 9002
-
No priming required for most substrates
-
No discolouration
-
Low modulus elastometric sealant
-
Security applications
-
Potable water approval
-
Petroleum & wash down environment
-
Chicken, poultry & food environment
-
Paintable
Bostik Seal 'N' FLEX FC is commonly used in a variety of industrial and commercial applications, including sealing floor joints in warehouses, car parks, and other facilities with heavy vehicle traffic. Its fast-curing properties make it ideal for situations where downtime must be kept to a minimum, while its high strength and chemical resistance ensure that it will provide long-lasting protection for the joint.
Application
.png)
Limitation
-
Should not be used in highly chlorinated areas such as swimming pools, spas etc.
-
Should not be used in glazing applications subject to UV light radiation or direct sunlight exposure.
-
Should not be applied or finished with wet tooling techniques, using solvents, water or detergent/ soap solutions.
-
Should not be applied to unpredictable porous surfaces such as marble, limestone, or granite unless a standard of appearance has been agreed on as a result of testing for stain and/or discoloration.
-
Do not use in interior or exterior structural sealing below the waterline in marine applications.
-
Do not use in applications less than 5mm in width or less than 6mm in depth.
-
Do not apply to surfaces with special protective or cosmetic coating such as mirrors, reflective glass or surfaces coated with Teflon, Polyethylene, Polypropylene or PTFE.
Colour
Packaging
