APPLICATION DIRECTION

1. Surfaces must be clean, dry and free of dirt, grease, oil or water.

2. Surfaces should be cleaned with alcohol, M.E.K. or other suitable solvent. Do not use soap or detergent.

3. For a neat finish, apply masking tape and remove it before sealant skins over.

4. Cut nozzle at 45° angle to desired bead-width and apply to substrate with cartridge gun.

5. Tool the sealant within 15 minutes of extrusion.

6. Uncured sealant can be cleaned up with mineral spirits.


OUR WEBSITE IS http://www.velocitydiy.com
CONTACT NUMBER IS +6014-9891223