| Minimum Guaranteed Power |
|
| 4 ohms stereo (per channel) |
1280 W |
| 8 ohms stereo (per channel) |
1000 W |
| 8 ohms bridge mono |
2560 W |
| Frequency Response (1W) |
20 Hz – 20 kHz, +0/-1 dB |
| Frequency Response (1W) notes |
Measured in a full space (4π) condition. |
| Transient Intermodulation Distortion(THD) |
< 0.5%, 20 Hz – 20 kHz |
| Transient Intermodulation Distortion (IMD) |
< 0.6 %
(60 Hz and 7 kHz at 4:1, from full rated output to -30 dB) |
| Conversation Rate |
> 10 V/μs |
| Voltage Gain |
41.6 dB |
| Damping Coefficient |
> 200
(8 ohms, 10 Hz to 400 Hz) |
| Signal-to-Noise Ratio |
> 100 dB |
| Signal-to-Noise Ratio notes |
Referenced to rated output power, 20 Hz to 20 kHz, A-weighted |
| Crosstalk |
-75 dB @ 1 kHz, -59 dB @20 kHz |
| Crosstalk notes |
Referenced to rated output power |
| Input Sensitivity (Rated power @ 8 ohms) |
0.775 V |
| Input Sensitivity notes |
According to IEC standard, tested for 2 hours under pink noises with a crest factor of 6 dB. |
| Input Impedance (Rated) |
20k ohms (balanced inputs)
10k ohms (non-balanced inputs) |
| Signal Input/ Output Connector |
One balanced XLR input and one XLR LINK output per channel |
| Amplifier Output Connector |
One Speakon signal output interface and one set of terminal output interface per channel |
| Front Panel Control |
Power switch and channel gain knob |
| Rear Panel Control |
Output mode switch: Stereo, Parallel, Bridge-mono |
| Power Indicator |
Blue |
| Signal Indicator |
Green |
| Clipping Indicator |
Yellow |
| Fault Indicator |
Red |
| Power Cord Specifications |
Plug: 10 A, 250 V
Cable: CCC 3 x 1.0 mm2 x 1.5 m |
| Amplifier Housing |
Built-in 2U standard rack |
| Protection |
Protection against short circuit, no load, power on/off noise, radio interference and abnormal temperature |
| Ventilation |
Air convection mechanism from front to back |
| cooling system |
DC motor fan for heat dissipation and cooling |
| Dimension (W x H x D) |
482 mm x 88 mm x 258.5 mm |
| Net Weight |
15 Kg |
